White earphone cable, not long will become dirty, this may affect your image, so how to clean the earphone cable? Here's your advice.
Simple method of cleaning earphone cable
Soapy water: take a small piece of soap, melt it in warm water, wipe the earphone cable with a small amount of cotton theater solution, and then dry it with a dry towel. Of course, it can also be put in dry rice for several hours. Note: do not clean the interface.
Toothpaste: squeeze out a little toothpaste, mix a small amount of water, and then take a small amount of cotton cloth to wipe, and finally dry with a dry towel. It is also not possible to clean the interface.
Alcohol: use cotton to drop alcohol, wipe along the earphone cable, and finally air dry. This method can clean the connector, but alcohol can easily make the earphone cable aging, and it is easy to harden after a long time. This method can also be replaced by an alcoholic wipes.
White vinegar: use cotton to drop white vinegar and wipe along the earphone cable. This method tastes a little heavy, and finally wipe it with cotton cloth and water. Also, do not clean the interface.
How to better protect our earphone cable
1. We want to better protect our earphone wire. First of all, we need to pay attention to not using the earphone as a toy. If you wrap the earphone too much on your fingers and swing it around, all of these can cause excessive tension on the internal wire of the headset, causing damage and fracture of the internal wire.
2. If friends like sports, they should choose wireless earphones as far as possible when choosing earphones, because the sweat you produce in sports will corrode the surface layer of the earphone cable. If you don't wipe it off in time, it will cause irreparable loss to the earphone cable after a long time. Let our earphone go to the repair shop!
3. Don't be too violent when storing. You can wrap the earphone properly and put it into our storage box and other products. Don't put too sharp objects around. This can not only protect our headphones better, but also make you look more tidy.
How to connect the earphone cable?
Cut off the outer black rubber layer and leak out the wire inside. Straighten out every thread. Don't mix. There's white plastic fiber inside each thread. Pick it out and cut it off. Use a lighter to burn the insulation out of the copper wire. Note: the burning time should not be too long, so as to avoid burning the copper wire, as long as a few times on the flame. After burning, the ashes of the insulation layer still remain on the wire, which can be scraped off with scissors and other articles to ensure that the connection can be conducted.
Connect the corresponding thread ends. If you can't tell which one to the other, there are two ways: 1. Look at the color; 2. Plug in the earphone to test how it works properly. The combination of the two methods can accurately distinguish. After connection, wrap the ends with transparent tape or other insulation. First of all, this is to avoid mutual conduction short circuit, in addition, it also plays a fixed role. If possible, put the connection in a small adjustable box, which not only protects the stability of the connection, but also keeps the earphone beautiful after repair.
